Product code: 0016
+ PRODUCT DESCRIPTION:
PLA-4N Stage2
*First released in China, Taiwan and Korea
PLA-4N Stage2 has the function of detecting the press load with four(4) pieces of strain gauge sensors. It displays the accurate load during press processing, and output stop signals and stops a press machine immediately when abnormality is detected. Monitoring cannot be ignored when there are eccentric loads for each stroke, and furthermore, load monitoring extends the life of dies, prevents friction and wear of presses, also promotes quality control and rationalization.
Features
Easy to know the balance of loads applied to the left and right sides of the press, and to know improper balance, load center, etc., it facilitates die maintenance and quality control.
As a overload protector, it prevents from the damage of the dies by detecting double hits, mis-feed, change of material thickness etc., and estimates die regrinding intervals.
By knowing the suitable load for products, the selection of the press is facilitated.
The detector can be used to simultaneously set absolute value comparison (set value of upper/lower limits) and comparison with the value of the previous time.
The digital LED display is easy to read, and the bar display shows the left load and the right load in percentage.
Specifications
|
●Power Supply and Output section |
Power supply |
85-264 VAC, 50/60Hz |
|
Power consumption |
75W or less |
|
|
Output contact |
1A・1B(emergency stop output / auxiliary output) |
|
|
Output contact capacity |
250VAC or less, 5A or less Cosφ=1 |
|
|
●Detection section |
No.of channels |
4 channels |
|
Detection range |
100kN or more, available for press up to 90,000kN in capacity |
|
|
Repeatability |
within 1% of device press capacity/Within 100-800% of channel capacity |
|
|
Sensor |
Strain gauge type 4-bridge strain sensor |
|
|
●Display section |
Display |
1/2 inch 7-segment red LED, five-digit (per channel) |
|
●Others |
Backup |
With semiconductor memory, backup time:10 years or more |
|
Maximum SPM |
2,000 spm (spring-back load) |
|
|
Temperature range |
working: -10℃-40℃(non freezing) / Storage:-20℃-55℃ |
|
|
Humidity range |
10-85%RH (at wet bulb temperature of 229℃ or less, non condensation) |
